insulin syringe
syringe render top1
syringe render top2
syringe render top3

Droplet® Insulin Syringes

Sterile single-use syringe for the injection of U-100 inuslin only.

6001 0.3mL 31G 6mm 100pc per box; 5bx per case
6002 0.5mL 31G 6mm 100pc per box; 5bx per case
6003 1mL 31G 6mm 100pc per box; 5bx per case
6004 1mL 31G 8mm 100pc per box; 5bx per case
6005 0.5mL 31G 8mm 100pc per box; 5bx per case
6006 0.3mL 31G 8mm 100pc per box; 5bx per case
6007 1mL 30G 12.5mm 100pc per box; 5bx per case
6008 0.5mL 30G 12.5mm 100pc per box; 5bx per case
6009 0.3mL 30G 12.5mm 100pc per box; 5bx per case
6011 1mL 30G 8mm 100pc per box; 5bx per case
6012 0.3mL 30G 8mm 100pc per box; 5bx per case
6013 1mL 30G 8mm 100pc per box; 5bx per case
Contact Us

Instructions

  1. Twist and remove the large back-end cap to expose the plunger.
  2. To expose needle, twist and pull off the orange cap, being careful not to bend the needle or let needle touch anything.
  3. Pull the plunger down to let desired units of air into syringe. The amount of air should be equivalent to the units of insulin you will take.
  4. Push the needle through the center of rubber top of insulin bottle until the entire needle goes in, then slowly push down on the plunger to push the air into the bottle.
  5. Leave needle in the insulin bottle. Invert bottle and syringe.
  6. Pull down on the plunger to draw the insulin into the syringe, aligning the top black line of plunger with desired amount of units on the syringe.